View Single Post
Old 12-14-2006, 04:22 AM   #7
William Henniger
Affiliate William Henniger is offline
 
William Henniger's Avatar
 
Profile:
Join Date: May 2006
Location: Columbus  OH
Posts: 1,059
My rope is not rigged up yet, I just tied it around the bar to get it off the floor.

Eugene, nice simplistic design for a turning bar. I had to use a board for an anchor point due to the compressed lumber behind it. I used 4.5" lag screws for anchor board and 2" lag screws for pipe flanges. People were looking at with much curiosity in Home Depot while I was fitting my pullup bar in the aisle.

We are very close to signing our lease in Columbus,OH. I can't wait to rig 20' ropes and weld up an insane pullup station.
  Reply With Quote