Thread: Home made rings
View Single Post
Old 05-28-2006, 05:10 PM   #5
Lee Lister
Member Lee Lister is offline
 
Profile:
Join Date: Jan 2006
Location: Melborne  Victoria
Posts: 24
I ran some webbing through the PVC ring with a small buckle that tighten and inserted inside the PVC. This closed off the ring with only a small gap left. I then cut a small piece of PVC pipe, about 50cm, sliced in half length wise and flared slightly so it would sit over the top of the join. A screw on either side of the join holds the ring together nicely.
I put some duct tape over this section to reduce any rubbing happening against the arms. I also place the straps over this area when I use the rings. I originally planned for these to be my test rings with the intention of making another pair, but they worked out better than I thought and will do until I can buy a set...
Hope this helped, Lee
  Reply With Quote