View Single Post
Old 10-28-2008, 12:07 PM   #3
Nick Cruz
Member Nick Cruz is offline
Nick Cruz's Avatar
Join Date: Jun 2006
Location: Anaheim  CA
Posts: 490
Re: Plates getting stuck on one end of an Oly bar: solution?

I have the same problem with a few of my plates. They are old school bumpers and I have never been able to determine who they are made by. I found that the plates went on one end of the bar much easier than the other end. I tried to do some sanding but it wasnt helping too much. I ended up marking the plates and the bar so I knew which plates to load onto which side of the the bar.

Hope that helps some.

Fullerton, CA There will be blood!
  Reply With Quote