Back (lower)went out 9 months ago - big drama; ambulance ride and all. Back got better after a few months. PTx advised that and deadlifts are very bad. PTx explained that injury mechanism was arching back under load. Nevertheless, did WOD that involved deadlifts with very light weight (135) and tried hard to focus on good form. Next day, back was very "pingy" - threatening spasms but none materialized. Day after that, back was o.k. and continued with WODs, which didn't involve deadlifts or OLY weightlifting with no problems. Point of all of this is that I really want to fully participate in CF: I firmly believe that deadlifts and "power moves" are important. At the same time, I can't do any CF if my back is out. Am I doing something wrong? Any advice would be greatly appreciated. Thanks in advance.
Either start light and gradually work your way back up to "heavy" lifts or alternatively invest in a trap bar and use that instead of regular deadlifts and squats. There are plenty of good articles on the net re: trap bars. Some people with long legs and short torsos find the trap bar deadlift to be more comfortable and allows them to attempt max lifts without the pain.
Hope this helps
"(PTx explained that injury mechanism was arching back under load)". Most of the time problems from heavy deadlifting are from back bowing into "flexed" position. Most of the arching injuries I have been made aware of are from push pressing overhead pressing. Is this the case?
The biggest advice I can give is do your best to
1-Maintain a neutral back position, somewhere between flexion and extension.
2-Strengthen your midsection
4-In my experience people with back injuries who avoid "rebuilding the area" NEVER RECOVER
(Message edited by vcraig on January 24, 2006)
Fellas: Thanks very much for the response.
Kevin: I'll try going even lighter and graduating from there. Then I see about a trap bar.
Craig: ("Most of the time problems from heavy deadlifting are from back bowing into "flexed" position. Most of the arching injuries I have been made aware of are from push pressing overhead pressing. Is this the case?") Short answer: Yes. Had a tendency to over-arch (i.e., stick butt way out) while squatting pretty heavy. This and some other bad habits PT belived cause back to go out. To be clear, I personally don't think deadlifts caused the problem. I had done some during the week before my back went out but I was sitting with poor posture in my chair at work when it went out. But it does seem that there is some arching under load at the start and finish of the deadlift (see frame 1 and 7 on the crossfit.com deadlift slideshow). In any event, it sounds like you are suggesting something more nuetral than the slideshow, which I'll certainly try.
Thanks again for your thoughts.
|All times are GMT -7. The time now is 08:54 AM.|
Powered by vBulletin® Version 3.6.8
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
CrossFit is a registered trademark of CrossFit Inc.